Clients Can't Establish Connection

The following diagram shows the troubleshooting procedure if clients can't establish a FASP transfer connection to your Point-to-Point. Follow the instructions to identify and resolve problems:

Clients cannot connect to your Point_to_Point
  1. Test SSH ports
    To verify the SSH connection port, on the client machine, open a Terminal or a Command Prompt, and use the telnet command to test it. For example, to test connection to a computer ( through a port (TCP/33001), use this command:
    # telnet 33001

    If the client cannot establish connections to your Point-to-Point, verify the port number and the firewall configuration on your Point-to-Point machine.

  2. Test UDP ports
    If you can establish an SSH connection but not a FASP file transfer, there might be a firewall blockage of FASP's UDP port. Please verify your UDP connection.
  3. Verify SSH service status
    If there is no firewall blockage between the client and your Point-to-Point Client, on the client machine, try establishing a SSH connection in a Terminal or a Command Prompt: (Point-to-Point Client address:, TCP/33001)
    # ssh aspera_user_1@ -p 33001

    If the SSH service runs normally, the client should see a message prompting to continue the connection or for a password. However, if you see a "Connection Refused" message, which indicates that the SSH service isn't running, review your SSH service status. Ignore the "permission denied" message after entering the password, which is discussed in next steps.

  4. Applied authentication method is enabled in SSH
    If you can establish a SSH connection, but it returns "permission denied" message, the SSH Server on your Point-to-Point Client may have password authentication disabled:
    Permission denied (publickey,keyboard-interactive).

    Open your SSH Server configuration file with a text editor:


    To allow public key authentication, add or uncomment the PubkeyAuthentication yes. To allow password authentication, add or uncomment PasswordAuthentication yes. Here is a configuration example:

    PubkeyAuthentication yes
    PasswordAuthentication yes

    To reload SSH service, execute the following command:

    $ pfexec svcadm refresh ssh
  5. Verify that the user credentials are correct, and has sufficient access permissions to its docroot

    To make sure that the client can establish a SSH connection to your Point-to-Point, and has correct system user credentials, use this command on the client machine: (Connect Server address:, login: aspera_user_1/aspera, TCP/33001)

    $ ssh aspera_user_1@ -p 33001
    aspera_user_1@'s password:

    Enter the user's password when prompted. If you see "Permission denied" message, you may have a wrong user credentials, or the user has docroot configured and doesn't have sufficient access permissions to access it. Refer to Setting Up Transfer Users for instructions about setting up the user account, and review the user's docroot directory permissions.

If you still encounter connection problems after going through these steps, contact Technical Support.