Testing a User-Initiated Remote Transfer

Follow the steps below to test an incoming connection from a remote client machine to the Point-to-Point Client.


  • The client machine must have an Aspera transfer product, such as IBM Aspera Desktop Client or IBM Aspera CLI, installed on it. Aspera CLI, the command line client, is freely available for download from the following site:


  • The server must have at least one Aspera transfer user (a system user account that is configured to authenticate Aspera transfers) configured on it. For instructions on adding a transfer user, see Setting Up Transfer Users.
  1. On the client machine, verify your connection to Point-to-Point Client.
    Run a ping command to verify connectivity to the host. In this example, the address of Point-to-Point Client is and the output shows successful responses from the host.
    # ping
    PING ( 56 data bytes
    64 bytes from icmp_seq=0 ttl=64 time=8.432 ms
    64 bytes from icmp_seq=1 ttl=64 time=7.121 ms
    64 bytes from icmp_seq=2 ttl=64 time=5.116 ms
    64 bytes from icmp_seq=3 ttl=64 time=4.421 ms
    64 bytes from icmp_seq=4 ttl=64 time=3.050 ms

    If the output returns "Destination host unreachable," check the firewall configuration of the server. For more information, see Clients Can't Establish Connection.

  2. On your client machine, initiate a transfer to Point-to-Point.
    Run the following command on your client machine (where aspera_user_1 is the example transfer user):
    # ascp -P 33001 -T --policy=fair -l 10000 -m 1000 /client-dir/files aspera_user_1@ 

    This command specifies the following values for the transfer:

    Item Value
    Host Address
    Transfer User aspera_user_1
    Files to upload /client-dir/files
    Destination Folder {user's docroot}/dir
    Transfer Options
    • Maximum transfer rate = 10 Mbps (-l 10000)
    • Minimum transfer rate = 1 Mbps (-m 1000)
    • TCP port that is used to initiate the FASP session = 33001 (-P 33001). This command does not alter ascp or the configuration of your SSH server.
    • Disable encryption (-T)
    • Fair transfer policy (--policy=fair)

If you cannot establish a connection to Point-to-Point, see Clients Can't Establish Connection.