You can monitor and adjust file transfer speed by clicking
open the IBM Aspera Connect Browser Plug-in Transfer Monitor
dialog. If you have
sufficient server privileges and your transfer server is configured to allow it, you may
modify the following in this dialog:
|Transfer progress bar
||Adjust the file transfer speed by clicking and sliding the transfer
||Click to view the destination folder of the transferred files.
||Click to stop the transfer session.
||Select the transfer policy from the drop-down list:
- The transfer transmits data at a rate equal to the target rate,
although this may impact the performance of other traffic present on
- The transfer rate is adjusted to use the available bandwidth up to the maximum rate.
- The transfer attempts to transmit data at a rate equal to the target
rate. If network conditions do not permit that, it transfers at a
rate lower than the target rate, but not less than the minimum
- The transfer rate is less aggressive than Fair when sharing
bandwidth with other network traffic. When congestion occurs, the
transfer rate is decreased to the minimum rate, until other traffic
Note: You can only switch between High and Fair transfer policies if the host is
IBM Aspera Enterprise Server version 3.0 or later.